Sink controlling other sinks temp

Discussion in 'Plumbing Forum, Professional & DIY Advice' started by TheNewGuy, Jun 12, 2014.

  1. TheNewGuy

    TheNewGuy New Member

    Apr 8, 2014
    I am having a small issue, I have three sinks as seen in the picture, when I turn the hot water on for sinks 2 and 3 the water becomes luke warm, i let it run for a good 5 minutes and still no change in the temperature, while 2 and 3 are running I turned on sink 1, after about 10 seconds the temp on sinks 2 and 3 rise to where it's supposed to be, sink 1 temp stays cold though, but if you turn 1 off again 2 and 3 temps drop back down to luke warm. Any help would be great thanks :) IMG_20140612_094840_730.jpg
  2. hj

    hj Moderator & Master Plumber Staff Member

    Aug 31, 2004
    Cave Creek, Arizona
    Yo are describing a malfunctioning hot water recirculation system, so you may need a competent plumber to diagnose it and make any needed repairs.
  3. Sponsor

    Sponsor Paid Advertisement

Similar Threads: Sink controlling
Forum Title Date
Plumbing Forum, Professional & DIY Advice Vintage cast sink center hole? Tuesday at 12:34 PM
Plumbing Forum, Professional & DIY Advice Is this setup ok? Wet Vent/Washer/Utility Sink Monday at 9:09 AM
Plumbing Forum, Professional & DIY Advice sink drain into toilet drain Sunday at 7:20 PM
Plumbing Forum, Professional & DIY Advice Newbie Wet Vent Question: Tub->Toilet->Sink Sunday at 6:21 PM
Plumbing Forum, Professional & DIY Advice Kitchen sink pipes configuration Saturday at 12:58 PM

Share This Page