c_anthony27
New Member
I am looking to replace my super stor tank unit with an AO Smith 50 gallon high recovery gas water heater
the super stor has been installed for about 12 years now and its always been terrible
runs out of hot water after about 2 showers
its been like this since it was brand new
My question is regarding the lines that come off the boiler at the circulating pump manifold
my setup has the circ pump for the super stor tank at the end of the manifold
and that line runs in to a port on the tank marked “boiler in”
and there is another port on the tank marked “boiler out”
do i just remove that circ pump and connect those 2 lines together ?
(the lines marked boiler in and boiler out)
and than the new water heater just gets its normal in and out water lines conmected and its gas line
correct ?
or am i missing something here ?
i am going to attach some pics
the boiler in line is circled in red
and the boiler out line is circled in blue
thank you for any help
the super stor has been installed for about 12 years now and its always been terrible
runs out of hot water after about 2 showers
its been like this since it was brand new
My question is regarding the lines that come off the boiler at the circulating pump manifold
my setup has the circ pump for the super stor tank at the end of the manifold
and that line runs in to a port on the tank marked “boiler in”
and there is another port on the tank marked “boiler out”
do i just remove that circ pump and connect those 2 lines together ?
(the lines marked boiler in and boiler out)
and than the new water heater just gets its normal in and out water lines conmected and its gas line
correct ?
or am i missing something here ?
i am going to attach some pics
the boiler in line is circled in red
and the boiler out line is circled in blue
thank you for any help