I read all of the posts concerning the Veneto II. I had the same issues when I had to learn about the internals, and then figure out how to replace them once I received the new parts.
But now I have another problem. I replaced the entire flushing mechanism less than a year ago, and now it vibrates and leaks. It appears that the gasket at the bottom is not sealing properly. It's less than a year old, so I'm wondering if there is a setting to apply more downward pressure to get the gasket to seal, or is it simply a matter of replacing the lower gasket?
Any advice would be much appreciated.
But now I have another problem. I replaced the entire flushing mechanism less than a year ago, and now it vibrates and leaks. It appears that the gasket at the bottom is not sealing properly. It's less than a year old, so I'm wondering if there is a setting to apply more downward pressure to get the gasket to seal, or is it simply a matter of replacing the lower gasket?
Any advice would be much appreciated.