Patrick North
New Member
Putting in a bathroom on the third floor and I’m a little anxious about shower water pressure. The shower stall will only have a single head- no multiple heads, jets, etc.
My question is- all things being equal- will I improve anything by piping ¾†lines to a ¾†mixer as opposed to ½�
If I used ¾†supplies/mixer I’d also try to keep the shower head at ¾â€. Would I lose all benefit of the ¾†supplies if I went down to ½†shower head?
While I’m at it- any recommendations for a ¾†combo mixer/volume control valve, or is there no such animal without spending $$$$?
Thanks,
Patrick
My question is- all things being equal- will I improve anything by piping ¾†lines to a ¾†mixer as opposed to ½�
If I used ¾†supplies/mixer I’d also try to keep the shower head at ¾â€. Would I lose all benefit of the ¾†supplies if I went down to ½†shower head?
While I’m at it- any recommendations for a ¾†combo mixer/volume control valve, or is there no such animal without spending $$$$?
Thanks,
Patrick