1/2 to 3/8 reducer on chrome lavatory/toilet supplies ok?

Users who are viewing this thread

dmr

New Member
Messages
1
Reaction score
0
Points
0
I am installing a new pedestal sink and toilet in our guest bathroom.

I ordered the kohler chrome angle supplies listed as compatible with the sink and toilet on the vendor's website.

Unfortunately, I neglected to note that there were 3/8 and 1/2 inch versions available. (and I'm only assuming they all come in alternate sizes, haven't been able to track down a p/n for the toilet supply in 1/2 yet) Of course, when I went to attach the stops, I realized they weren't going to work.

Any foul in simply using 3/8 to 1/2 reducers to make 'em all fit?

-dmr
 

Cass

Plumber
Messages
5,947
Reaction score
9
Points
0
Location
Ohio
You could use the reducer but it will look kinda goofy and stick out.
 

hj

Master Plumber
Messages
33,613
Reaction score
1,053
Points
113
Location
Cave Creek, Arizona
Website
www.terrylove.com
stop

Did you put the valve exactly where the Kohler sheet specified? Otherwise it is not going to work anyway, because the riser pipe is not flexible.
 
Top