Search results

Looks like it's probably this cartridge (assuming it's a 38 point stem): (Hot : DA507173) http://www.supply.com/danze-da507173-chrome/p276634 (Cold : DA507174) http://www.supply.com/danze-da507174-chrome/p276635 Though I'm not sure what manufacturer the faucet is. Perhaps Glacier Bay...

Thanks for the reply. Our plumber is telling us that we could use a 3/4" to 1/2" bushing and then use a 1/2" spout. He points to the Kohler twin ell installation as an example. American standard offered no real guidance, saying "our twin ell has been discontinued, but any other twin ell...

We're building a new bathroom and installing a 36" x 72" tub in an alcove and are trying to find a cost effective way of pulling ~80 gal. for the tub in a reasonable amount of time, while also being able to divert to a shower head. The lowest cost thermostatic mixing valve with volume control...

We've had a new sewer line (from our house to the street) installed, along with replacing all plumbing under our basement slab. (We've still yet to re-pour the slab.) The sewer contractor installed a sanitary tee between the building sewer and drain near the inside wall for a cleanout. Our...

Thanks for your reply. We've decided to void our warranty (just to labor portion of the warranty -- they'll still supply parts) and put the pump against the outside wall, allowing the wet wall to be on an interior wall. Having drain-tile on the inside perimeter of the basement sealed the deal...

We're adding a 36" x 72" whirlpool tub to a new bathroom in our basement, with that tub framed in an alcove so it can also be used as a shower. Because the warranty for the tub requires pump/motor access to be a specific way (access panel on the short side of the tub, opposite the drain side...