Search results

1) I have a Fleck 5600 Econominder on a resin tank with .75 cubic ft. of resin. Based on everything I've seen, that amount of resin would have a capacity of about 24,000 grains. However, the cog wheel with the hardness numbers indicates the capacity is 18,000 grains. Should I a assume 24,000 and...

I need to move a softener to another house and want it as light as possible. Is it OK to drain the water by merely laying the softener on it's side? I assume that the resin would just settle back to where it needs to be after I set it upright again?? If above is not OK, what is the simplest...

My Fleck 5600 recently started jamming so I replaced the pistons, seals and spacers. The old ones were not in terrible condition. However, at the bottom of the cylinder I found three plastic pieces (photo below). I suspect that this was the culprit. What I am wondering is where these came from??