JasonS
New Member
Hello!
Are there any participants in this forum who are knowledgeable about Rainsoft Q2 systems anymore?
I've replaced the O-rings on the piston and the system runs through a cycle in a mostly normal manner. The system fills the brine tank with water, but never draws water from the brine tank.
Currently the Tri-Guard is full after the cycle completes and the white ball remains pegged at the top of the Tri-Guard.
Here's what I've done:
* Replaced piston O-Rings
* Removed brine line that goes from Tri-Guard to tank and ensured it is clear and unobstructed
* Removed smaller line from Tri-Guard to valve and made sure it is unobstructed
* Confirmed that the little venturi washer is inserted into the Tri-Guard fitting that the line from the valve connects to
* Confirmed that the screen in between the Tri-Guard line and the valve is clear and unobstructed
* Ensured there is no debris blocking the bottom of the Tri-Guard copper line coming from the valve
* Confirmed that the poppet is installed between the Tri-Guard and the copper line from the valve
* Confirmed that the o-ring on the poppet is in good shape
I'm stumped as to why the unit is not drawing brine.
Thanks,
Jason
Are there any participants in this forum who are knowledgeable about Rainsoft Q2 systems anymore?
I've replaced the O-rings on the piston and the system runs through a cycle in a mostly normal manner. The system fills the brine tank with water, but never draws water from the brine tank.
Currently the Tri-Guard is full after the cycle completes and the white ball remains pegged at the top of the Tri-Guard.
Here's what I've done:
* Replaced piston O-Rings
* Removed brine line that goes from Tri-Guard to tank and ensured it is clear and unobstructed
* Removed smaller line from Tri-Guard to valve and made sure it is unobstructed
* Confirmed that the little venturi washer is inserted into the Tri-Guard fitting that the line from the valve connects to
* Confirmed that the screen in between the Tri-Guard line and the valve is clear and unobstructed
* Ensured there is no debris blocking the bottom of the Tri-Guard copper line coming from the valve
* Confirmed that the poppet is installed between the Tri-Guard and the copper line from the valve
* Confirmed that the o-ring on the poppet is in good shape
I'm stumped as to why the unit is not drawing brine.
Thanks,
Jason