Recent content by Drockalisty

Thanks for the help! Got it working properly.

This picture isn't the best but basically what the wires are landed to are the Red and White T spots. They ran in series Red from the yellow wire to Red on the SR501, then wire nutted white from the yellow wire to red of another thermostat wire that comes from the thermostat and white from the...

Looking to get some advise on how to properly wire up a new honeywell zone valve. I recently had a plumber install a water baseboard heater in my garage. Problem is he didn't or the electrician didn't properly wire up the zone valve. The yellow wires run up to my taco SR501 1 zone switching...

The .6 - .8 flow rate is the max they will flow too. The flow meters are fully open.

Almost All the pex tubing is 1/2”. One room which is the furthest from the manifolds is 5/8”. As far as floor type, I have tile in the kitchen, entrance and bathrooms. Carpet in all the bedrooms and hallway upstairs. And quick lock pergo laminate/wood downstairs in great room, office, and dining...

It doesn’t look like the plumber installed the outdoor reset control.... If I don’t have that am I sol on making this thing work in the cold temps?

Hi all, Im looking for advise on my new house/ boiler. Our house is just over 2300 sq ft 3 bedroom/2.5 bath/ office with vaulted ceilings in the master bedroom and great room. We have radiant infloor heat thru out the house. Originally we had 3 zones (thermostats) in the house. One downstairs in...