samgillis
New Member
I've done some reading on the posts on here about fluoride removal and the general consensus is that you need a lot of either bone char carbon or activated alumina to remove fluoride from a POE perspective. These all seemed to assume higher levels of fluoride.
However, my water report lists that fluoride is added to only an average of 0.2ppm in my city. Would a 4.5x20" big blue style filter (1" connections) be practical to reduce this amount of fluoride? If so, would bone char or activated alumina be the way to go? Or would this setup just not do a very effective job and thus be a waste of time and money?
However, my water report lists that fluoride is added to only an average of 0.2ppm in my city. Would a 4.5x20" big blue style filter (1" connections) be practical to reduce this amount of fluoride? If so, would bone char or activated alumina be the way to go? Or would this setup just not do a very effective job and thus be a waste of time and money?
Last edited: