Ron_Jeremy
Member
I am trying to install an Efergy True Power Meter. Basically, I am supposed to clamp a sensor onto the two mains feed cables, then a white wire to a bus bar and a black wire to a free 15A breaker. The instruction manual is short and basic but I'm need some guidance in determining the equivalvent locations on my setup.
Here are the instructions:
Here's my setup:
My questions are:
1. Are the mains wires A & B or C & D?
2. Where is the 'neutral bus bar' so I can secure the white wire mentioned on step 3 in the instructions?
2. The breaker on the left half of the panel (second from the bottom) has no wire secured to it. Does this mean it is free to use (for step 4 in the instructions)?
Here are the instructions:
Here's my setup:
My questions are:
1. Are the mains wires A & B or C & D?
2. Where is the 'neutral bus bar' so I can secure the white wire mentioned on step 3 in the instructions?
2. The breaker on the left half of the panel (second from the bottom) has no wire secured to it. Does this mean it is free to use (for step 4 in the instructions)?