Tub to Shower Conversion

Users who are viewing this thread

Vince B

Member
Messages
35
Reaction score
1
Points
8
Location
Pennsylvania
I have a standard 30x60 fiberglass tub and I originally was going to do a 32" width base but decided to go with a 34" which will now bring the base out to a 1/2" from the end of the drywall that has a metal corner bead. Will this pose an issue for the install in any way? Should I just keep it 32"? We will also be having vinyl planks put in afterwards over the existing sheet vinyl and I am concerned about the trim and baseboards in that corner location as
well. Any guidance would be greatly appreciated.

Bath 1.JPG
Bath 2.JPG
 

Jeff H Young

In the Trades
Messages
9,792
Reaction score
2,473
Points
113
Location
92346
I dont think its a problem you do have to think it through even with a 32 inch pan
 

Vince B

Member
Messages
35
Reaction score
1
Points
8
Location
Pennsylvania
Yes, you are correct. I almost forgot that there is the existing tub flange to deal with. So I guess the question is it better to stick with the 32" or is it better to go out near the end of that wall with a 34". That's the big question!
 
Last edited:

Jeff H Young

In the Trades
Messages
9,792
Reaction score
2,473
Points
113
Location
92346
is it a full fiberglas shower or just a pan with tile on walls ? I would expect a bit more reveal with the 32 might be a tiny bit easier but on other hand 2 more inches in the pan might be nice
 

Vince B

Member
Messages
35
Reaction score
1
Points
8
Location
Pennsylvania
I know this is probably not want you want to hear, but here goes. It will be an Onyx base then 3 custom cut acrylic walls.
 

Tuttles Revenge

In the Trades
Messages
4,458
Reaction score
1,572
Points
113
It looks like a flat slab that has a slope to the drain. You will want to make sure you have a tiling flange of some sort that is glued on REALLY well. Most manufactures offer that from the factory. We just set an MTI pan and had them install a flange on 4 sides leaving a bit open of the door.
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks