TOTO problem

Discussion in 'Toilet Forum discussions' started by TR2000, Feb 4, 2006.

  1. TR2000

    TR2000 New Member

    Feb 4, 2006
    We installed a Toto Dalton toilet the week before Christmas.
    For some reson we can't keep the water level at the acceptable level.
    The water level slowly keeps creeping up and going over the over flow pipe.
    We've tried the adjustment screw and even bent the bar a little to the float.
    Is there a cure for this?
  2. jadnashua

    jadnashua Retired Defense Industry Engineer xxx

    Sep 2, 2004
    Retired Systems engineer for defense industry.
    New England
    The most likely thing I can think of is that there is a little bit of dirt/sand/crud on the sealing surface of the shutoff. This can easily happen on new installations if there is something in the supply line/shutoff etc. Usually, if you take the shutoff apart, it can be cleaned off/flushed out, and then it can seal again. Not sure how that one comes apart. One of the pros will have some direction. You can probably find a parts breakdown on the web. Many of the Toto's use a Korky refill valve. Not sure about the one you have.
  3. Sponsor

    Sponsor Paid Advertisement

  4. Terry

    Terry Administrator Staff Member

    Aug 17, 2004
    Bothell, Washington
    This one uses a rod and float ball.

    Sounds like a cleaning of the fill valve is needed.
    Last edited: Jan 28, 2011
Similar Threads: TOTO problem
Forum Title Date
Toilet Forum discussions Flush problems with Toto MS970CEMFG#01 Dec 12, 2016
Toilet Forum discussions Requesting help with Toto Entrada Tank installation problem May 15, 2016
Toilet Forum discussions Toto Aquia II install problem Mar 4, 2016
Toilet Forum discussions Problem with Flange Height for install the Toto Unifit Nov 11, 2015
Toilet Forum discussions Toto Aquia II - Rough-in Problem Jul 6, 2015

Share This Page