Studor Vent in bathroom remodel

Jsmallberries

Member
Messages
305
Reaction score
20
Points
18
Location
Zephyrhills, Florida
Bathroom remodel, ceiling opened and a plumbing vent stack has a "jog", so it can go around some framing and would be blocking the open ceiling plan. Big box recommended a Studor type vent as a solution. Just want to see what you all say about that.

Any solutions recommended?

The pipe on the left is for the washing machine. This is in a bathroom with a shower, toilet and sink. house vented w/standard roof vent stacks
 

Attachments

  • left wall.jpg
    left wall.jpg
    114.9 KB · Views: 135
  • vent jog.jpg
    vent jog.jpg
    67.1 KB · Views: 129

Reach4

Well-Known Member
Messages
41,820
Reaction score
5,112
Points
113
Location
IL
Are you asking where or how to mount the AAV? It must remain accessible and vented. AAV must be at least 4 inches above the trap arm. You could jog the AAV to the left with a pair of 45 bends.
 

wwhitney

In the Trades
Messages
7,314
Reaction score
2,100
Points
113
Location
Berkeley, CA
Where does the vent go above the offending jog around the beam?

If you want to remove that dry vent, you'd need to follow it up to where it connects to another vent, and remove that connection. You can't just cut the vent and put a cap on it. If, for example, the vent went straight up through the roof, and you just cut it and cap it, it will fill up with rainwater over time.

Your best bet is likely to figure out how to modify your ceiling plan to allow boxing in the existing vent without modifying it.

Cheers, Wayne
 

Jsmallberries

Member
Messages
305
Reaction score
20
Points
18
Location
Zephyrhills, Florida
Modification of plan might be best.

There might be other fixtures attached. Guess I could cap the roof vent and see which fixtures don't flow. The AAV would be inside the wall. or in the attic. Can they be any height over the trap?? What other cons are there?
Thanks
 

Jsmallberries

Member
Messages
305
Reaction score
20
Points
18
Location
Zephyrhills, Florida
If this plumbing vent stack connects to the washing machine, shower and sink but not the toilet, would that work? (Not allowed for commode, right?)
I could install it min 4 “ above trap arm, vented and accessible from the other side which is laundry room
 

Reach4

Well-Known Member
Messages
41,820
Reaction score
5,112
Points
113
Location
IL
If this plumbing vent stack connects to the washing machine, shower and sink but not the toilet, would that work?
Depends on how they are connected. I suggest you post a diagram of what connects to what.
 

Reach4

Well-Known Member
Messages
41,820
Reaction score
5,112
Points
113
Location
IL
If this plumbing vent stack connects to the washing machine, shower and sink but not the toilet, would that work?
Was this a hypothetical question, or is it related to what you think is going on?

You are not allowed to use the drainage from a laundry standpipe to vent a shower or sink. Why did you bring up shower and sink?

Here is the deal: if you are asking how to replace the vent pipe shown in your photo, it is very easy.

If you are asking how to use that pipe going into the slab to also vent shower or sink, that was not allowed with a vent thru roof, and would not be allowed with an AAV.


Would my idea of temporarily blocking vent at the roof, to see which fixtures don't drain?
No. Bad venting does not cause non-draining.
 

John Gayewski

In the Trades
Messages
5,168
Reaction score
1,685
Points
113
Location
Iowa
It's slab on grade, how would I tell that now?

Would my idea of temporarily blocking vent at the roof, to see which fixtures don't drain?
Why not just build a wall in front of the existing wall to cover the vent pipe? Or just jog the top of the wall around the pipe? Silly to go to a mechanical vent instead of the best option for something like this.
 

piwopok

Member
Messages
61
Reaction score
8
Points
8
Location
United States
Was this a hypothetical question, or is it related to what you think is going on?

You are not allowed to use the drainage from a laundry standpipe to vent a shower or sink. Why did you bring up shower and sink?

Here is the deal: if you are asking how to replace the vent pipe shown in your photo, it is very easy.

If you are asking how to use that pipe going into the slab to also vent shower or sink, that was not allowed with a vent thru roof, and would not be allowed with an AAV.


for more guide you can visit https://mcmanuskitchenandbath.com/
No. Bad venting does not cause non-draining.
A Studor vent (AAV) can work as a solution if it’s allowed by your local plumbing code and remains accessible for inspection. It’s designed to let air in to balance pressure but doesn’t vent gases outside, so you still need at least one main roof vent in the system. If possible, a better long-term fix is to reroute the vent with 45° fittings to clear the framing while keeping it tied into the main vent stack. That keeps it fully vented and maintenance-free. In short: Studor vent = okay if code allows; rerouting the pipe = best practice.
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks