Steam Shower

Discussion in 'Shower & Bathtub Forum & Blog' started by bindab, Feb 17, 2008.

  1. bindab

    bindab New Member

    Nov 9, 2006
    I am interested in installing or building a steam shower. My preference would be in buy a pre-made unit (like Wasauna). However, when I stopped by my local plumbing store I was advised against purchasing such a unit, because the acrylic polymers tend to discolor when exposed to heat.

    I have not been able to find any forums were these pre-built units are discussed. Does anyone have an opinion on these?

    Thank you,

  2. krow

    krow Plumber

    Feb 11, 2008
    Ontario, Canada
    I just repaired a unit sold by MAAX and manufactured by thermasol (California). #SC35. Its a cost effective unit. The initial installation was botched (by others) and I inherited the job to fix it. It never worked from the 1st day it was put in. The contractor walked away 1 1/2 years ago.

    The California folks were very informative and instrumental in getting this unit in working order. Great public relations from Thermasol and they were very interested of the final outcome of this unit's performance. They called me back days later to ask if unit worked. (and it did).

    I have installed a few and if you install it properly (as per installation instructions), they are great units
  3. Sponsor

    Sponsor Paid Advertisement

Similar Threads: Steam Shower
Forum Title Date
Shower & Bathtub Forum & Blog Steam shower question May 11, 2017
Shower & Bathtub Forum & Blog Steam Shower Generator Installation Nov 22, 2016
Shower & Bathtub Forum & Blog Free-standing steam shower? Mar 6, 2015
Shower & Bathtub Forum & Blog Framing a Two Level Steam Shower Bench: L Shaped Jan 28, 2015
Shower & Bathtub Forum & Blog Installing a fan inside your steam shower: Good idea or bad Jan 27, 2015

Share This Page