First of all, this is a *great* message board. Thanks Terry & Co.!
My wife and I have recently tiled our main bathroom. What an improvement over the (suspect) vinyl flooring that was in there before! We're also about ready to install an American Standard Cadet 3 toilet due to the 10" rough-in that we discovered. Fun stuff! Unfortunately, there is ONE tile that is a bit wonky -- just underneath the toilet, if you can believe it. Figures. If I shim the back of the toilet, however, it feels fine. The catch? It looks like it's going to take 4 pennies on each side in the back to make it right. Is that too much? Another option, perhaps, is to grind some tile down, but I don't really want to get into that...
Thanks!
My wife and I have recently tiled our main bathroom. What an improvement over the (suspect) vinyl flooring that was in there before! We're also about ready to install an American Standard Cadet 3 toilet due to the 10" rough-in that we discovered. Fun stuff! Unfortunately, there is ONE tile that is a bit wonky -- just underneath the toilet, if you can believe it. Figures. If I shim the back of the toilet, however, it feels fine. The catch? It looks like it's going to take 4 pennies on each side in the back to make it right. Is that too much? Another option, perhaps, is to grind some tile down, but I don't really want to get into that...
Thanks!
Last edited by a moderator: