I see this a lot and often times it’s an isolated incident so it’s tough to diagnose. What do you fellas do when you run into this? I have started flushing them, cleaning orfices and cleaning the flame rods. So far it’s going good. I was walking through the whole manual on 11 to troubleshoot but after doing that over and over and finding nothing wrong I just assumed it was a fluke, maybe the heater didn’t detect flame it a pressure fluctuation caused it to lose flame momentarily but otherwise is in good shape.
So, do you guys walk through the whole code on these or do you have a process you try before digging too deep?
So, do you guys walk through the whole code on these or do you have a process you try before digging too deep?