Price Pfister S103200, 3-handle shower valve manufacturer

[KasperTheFriendly]

Looking to repair a leaky diverter valve on my 3-handle shower. Inside the lip of the bath-faucet there is a logo that I would assume is the manufacturer's logo, and I have been unable to identify it.

the faucet

the logo inside the aforementioned faucet.
​

The logo (to my eyes) appears to be a partial tombstone with the letter "H" written inside.
The house it was installed is a late 40's home, but I am fairly certain the bathroom was last renovated in the late 80's.

Can anyone help me identify this manufacturer, so that I might find a good diverter replacement?

Best regards,
Kasper

 

[Marlinman]

Zinc spouts are normally produced by a diecast company. Not the faucet manufacturer. Can you post photos of the faucet and trim?

 

[Sponsor]

 

[KasperTheFriendly]

Zinc spouts are normally produced by a diecast company. Not the faucet manufacturer. Can you post photos of the faucet and trim?

 

[KasperTheFriendly]

Zinc spouts are normally produced by a diecast company. Not the faucet manufacturer. Can you post photos of the faucet and trim?

Absolutely.

Thank you for the responsiveness.

 

[Marlinman]

Your faucet was made by Price Pfister. Other trims and finishes are available.
Search "Price Pfister S103200"

 

[KasperTheFriendly]

Your faucet was made by Price Pfister. Other trims and finishes are available.
Search "Price Pfister S103200"

Indeed you are correct @Marlinman - thank you

For posterity: 01-31XA Series Installation manual