rmcderm313
New Member
Hi All,
I'm not sure what the correct sub-forum would be for this so please move it as appropriate. I've got a Homelite power washer and the trigger mechanism in the wand has failed. The internals of the trigger switch fell out and I can't get them back in correctly to hold pressure. Is this a standard part? I've search by keyword and even tried Google image search and I'm not getting any valuable results. I can just buy a whole new wand but would much rather just replace the part in the picture if possible. Inside of this part there is a brass/rubber seal, a ball bearing a spring and a plastic part that should act as a retainer for all the other parts. The silver piece at the top is the trigger and it extends about 3/4 of an inch when it's spring loaded.
Any leads would be appreciated.
Thanks,
Rob
I'm not sure what the correct sub-forum would be for this so please move it as appropriate. I've got a Homelite power washer and the trigger mechanism in the wand has failed. The internals of the trigger switch fell out and I can't get them back in correctly to hold pressure. Is this a standard part? I've search by keyword and even tried Google image search and I'm not getting any valuable results. I can just buy a whole new wand but would much rather just replace the part in the picture if possible. Inside of this part there is a brass/rubber seal, a ball bearing a spring and a plastic part that should act as a retainer for all the other parts. The silver piece at the top is the trigger and it extends about 3/4 of an inch when it's spring loaded.
Any leads would be appreciated.
Thanks,
Rob
