Sj22
New Member
Hi all, putting a shower pan base in basement due to height, plan to keep it as close to floor as possible. The drain 2” is very close to ground and has concrete around it.
I don’t think a sealant type drain will work due to size unless I go with a 1.5 inch and put it into the 2” pipe and seal it. Definitely not much pipe to hold the rubber seal for a screw type shower drain adapter.
Was thinking of cutting the drain adapter and using marine epoxy or polyurethane weld. The shower pan will be held down with expanding foam so minimal flex later.
Any thoughts? Another option should be to use a screw in surface drain adapter.
I don’t think a sealant type drain will work due to size unless I go with a 1.5 inch and put it into the 2” pipe and seal it. Definitely not much pipe to hold the rubber seal for a screw type shower drain adapter.
Was thinking of cutting the drain adapter and using marine epoxy or polyurethane weld. The shower pan will be held down with expanding foam so minimal flex later.
Any thoughts? Another option should be to use a screw in surface drain adapter.
Last edited by a moderator: