I am replacing an old toilet in a 1950's home. Cast iron flange in good shape but slightly off level and about 1 1/4 inches below floor level. I have been told many things to do including just double or triple up wax. I got the Oatey set-right extender kit and it looked like a good method and had good reviews. It says it is good for just about any type of flange including cast iron BUT how do I screw this to cast iron? I called Oatey Tech support and they said they were self tapping screws! Good luck going through cast iron. Should I drill the cast iron?
So I am open for suggestions. I suspect I will get many different ones. Hopefully I can make this work. I like to do things right, not half ass so whatever it takes minus replacing the original flange
Photos - http://www.crompton.com/download/DSC03824.JPG
http://www.crompton.com/download/DSC03825.JPG
http://www.crompton.com/download/DSC03826.JPG
So I am open for suggestions. I suspect I will get many different ones. Hopefully I can make this work. I like to do things right, not half ass so whatever it takes minus replacing the original flange
Photos - http://www.crompton.com/download/DSC03824.JPG
http://www.crompton.com/download/DSC03825.JPG
http://www.crompton.com/download/DSC03826.JPG