Mfg says you can PEX anywhere accept valve and tub spout which I understand but mfg does not say anything about valve and shower head
But someone said u should not use PEX there either...
What experts here think?
Also, is it possible that when installing bathtub - I might have put overflow cover(that round with 2 screws) just off the center?
because when I measure the center of this overflow cover - it comes like 15" from the edge of tub but tub is 29" wide
so it should be 14 1/2 - so is it possible that I might have put it like half inch off - or it can not go anywhere but always in center?
But someone said u should not use PEX there either...
What experts here think?
Also, is it possible that when installing bathtub - I might have put overflow cover(that round with 2 screws) just off the center?
because when I measure the center of this overflow cover - it comes like 15" from the edge of tub but tub is 29" wide
so it should be 14 1/2 - so is it possible that I might have put it like half inch off - or it can not go anywhere but always in center?