Steve P.
New Member
Hello, I have a 1993 vintage Model 60. Its been re-bed a few times, but lately a couple of issues have come up.
1. It wont change over to the next tank automatically, I have to do that manually daily. This is a non-electric model.
2. When the cycle starts, if there is any water running in the house there will be a lot of dark water for a few minutes. When I run it manually, I make sure no one is running water. We typically wait till the cycle is complete before running water again. Sometimes we get the accidental toilet flush.
I have inspected the "water meters" and they flow freely. The valves inside also move freely and everything is very clean. When it cycles, it takes the same amount of time around 25-30 minutes.
Any tips or advise would be very helpful.
Steve
1. It wont change over to the next tank automatically, I have to do that manually daily. This is a non-electric model.
2. When the cycle starts, if there is any water running in the house there will be a lot of dark water for a few minutes. When I run it manually, I make sure no one is running water. We typically wait till the cycle is complete before running water again. Sometimes we get the accidental toilet flush.
I have inspected the "water meters" and they flow freely. The valves inside also move freely and everything is very clean. When it cycles, it takes the same amount of time around 25-30 minutes.
Any tips or advise would be very helpful.
Steve