jobsite fan question

Discussion in 'Electrical Forum discussion & Blog' started by wrdtlpf, Mar 3, 2009.

  1. wrdtlpf

    wrdtlpf Carpentry/Handyman Service

    Joined:
    Dec 8, 2005
    Occupation:
    Carpentry/Handyman Service
    Location:
    Connecticut
    Hey guys- Not sure if this is the right place but not sure where else to look. I have a job site fan with a three position rotary switch: low, med and high. When I have it on any speed but most noticeably on low the fan's RPM will all of a sudden climb but not as high as if it were set to 'med'. Is the switch bad somehow and allowing some current to pass? Motor dying? Any input would be great, Thanks.
     
Similar Threads: jobsite question
Forum Title Date
Electrical Forum discussion & Blog Mini Split wiring Question Apr 16, 2017
Electrical Forum discussion & Blog Question about fan speed controller. Apr 12, 2017
Electrical Forum discussion & Blog Question on 3-wire Kitchen Range > 4 wire Nov 24, 2016
Electrical Forum discussion & Blog Question about Ceiling Fan wiring Nov 9, 2016
Electrical Forum discussion & Blog Another question: generator power necessary for 1/2 hp pump jet pump Oct 8, 2016

Share This Page