Jb9
Member
Hello,
I need to install my Toto toilet on the Geberit Carrier and I just want to confirm I understand the installation correctly. I have watched one of the videos 100 times but... I wanna get this right.
So I basically mark the waste and water inlet pipes at the plane where they enter the wall (I just finished the tile) AND THEN remove the pipes from the wall and then insert the waste and water inlet pipes into the Toto (fixture) and mark where they enter the plane of the fixture....
AND THEN
Take the difference between these two marks
AND THEN
Add 1/8"
And then take this measurement and cut from the end of both pipes.
Is this right?
Measure 10 times cut once
I need to install my Toto toilet on the Geberit Carrier and I just want to confirm I understand the installation correctly. I have watched one of the videos 100 times but... I wanna get this right.
So I basically mark the waste and water inlet pipes at the plane where they enter the wall (I just finished the tile) AND THEN remove the pipes from the wall and then insert the waste and water inlet pipes into the Toto (fixture) and mark where they enter the plane of the fixture....
AND THEN
Take the difference between these two marks
AND THEN
Add 1/8"
And then take this measurement and cut from the end of both pipes.
Is this right?
Measure 10 times cut once