NuNovice
New Member
Hi,
I've been going into my fleck to mess around with the settings provided by this board, and I noticed that 2-3x in that the settings for the capacity and reserve capacity keep resetting when I get back inside.
For example: I had set the capacity to 36000 since I have 1.5CU of resin. and the RC as 120.
When I go back in 4-5 days later the capacity always reverts back to 24K and RC reverts to 0. is this normal? If I go back in immediately after I change the settings they're exactly as I originally put them. It always happens 4-5 days later. the control unit is plugged in, and I haven't had any power outages. Do I have a faulty unit?
Thank you.
I've been going into my fleck to mess around with the settings provided by this board, and I noticed that 2-3x in that the settings for the capacity and reserve capacity keep resetting when I get back inside.
For example: I had set the capacity to 36000 since I have 1.5CU of resin. and the RC as 120.
When I go back in 4-5 days later the capacity always reverts back to 24K and RC reverts to 0. is this normal? If I go back in immediately after I change the settings they're exactly as I originally put them. It always happens 4-5 days later. the control unit is plugged in, and I haven't had any power outages. Do I have a faulty unit?
Thank you.