Iqraam Nabi
New Member
Hello,
I have a new system installed for 45 days now, 2 people live full time in my house and visitors from time to time. Wanted to know best settings for my new system, details below:
Hardness: 100 ppm
Chlorine: 5 ppm
Alkalinity 120 ppm
pH 9
Copper: .03 ppm
Iron: .03 ppm
Current settings setup by my plumber is using a lot of salt, probably have gone through 80-120lbs of salt in that time. Brine solution is higher than the salt in the system, I added a new 40lb bag just today but water still sits higher.
I used this video to do the baseline programming:
Any thoughts or ideas would be appreciated.
Edit 8.14.2021:
I've since adjusted some settings today to:
H: 6
C: 30K
BW: 5 min
BD: 60 min
RR: 5 min
BF: 6 min
https://www.aquatell.com/pages/water-softener-capacity-and-salt-settings-for-fleck-control-valves - used this for new setting guide
I have a new system installed for 45 days now, 2 people live full time in my house and visitors from time to time. Wanted to know best settings for my new system, details below:
Hardness: 100 ppm
Chlorine: 5 ppm
Alkalinity 120 ppm
pH 9
Copper: .03 ppm
Iron: .03 ppm
Current settings setup by my plumber is using a lot of salt, probably have gone through 80-120lbs of salt in that time. Brine solution is higher than the salt in the system, I added a new 40lb bag just today but water still sits higher.
I used this video to do the baseline programming:
Any thoughts or ideas would be appreciated.
Edit 8.14.2021:
I've since adjusted some settings today to:
H: 6
C: 30K
BW: 5 min
BD: 60 min
RR: 5 min
BF: 6 min
https://www.aquatell.com/pages/water-softener-capacity-and-salt-settings-for-fleck-control-valves - used this for new setting guide
Last edited: