Gdog
write diagnostic firmware for embedded industrial
Don't know if anyone has experience with this here, but thought i would give it a shot.
Dishwasher is a sears, fairly top end model, and about 3-4 yrs old, very good condition. Everything works just fine, but i am doing a thorough cleaning on it one day and notice the door seal at the lower corner is chafed and starting to tear.
So i think, no problem, order the part from sears, follow the instructions and install it. Now it leaks at both bottom corners of the door! Here are some pics of the bottom corners. Most grateful to anyone who can tell me what i did wrong.
Thanks!
Dishwasher is a sears, fairly top end model, and about 3-4 yrs old, very good condition. Everything works just fine, but i am doing a thorough cleaning on it one day and notice the door seal at the lower corner is chafed and starting to tear.
So i think, no problem, order the part from sears, follow the instructions and install it. Now it leaks at both bottom corners of the door! Here are some pics of the bottom corners. Most grateful to anyone who can tell me what i did wrong.
Thanks!