Am I getting the right parts for a pump install?

Users who are viewing this thread

rural_engineer

In the Trades
Messages
138
Reaction score
9
Points
18
Location
New York
Hi,

I'm putting in a pump in an existing, never used well. It's a 30' rock well with 12' of casing. There's 2" IPS DR11 HDPE running to the well. The pump is stainless with a 1-1/2" outlet. I'm wondering if I'm ordering the right parts to plumb it. Here they are, more or less from top to bottom.

2" Poly to 2" FPT compression fitting
PVC SCH40 2" to 1-1/4" Bushing
PVC 1-1/4" Nipple
Brass 1-1/4" Pitless
3 x Brass 1-1/4" Extra Long Male Insert Adapters & Stainless Clamps
1-1/4" 160PSI Polyethylene Pipe (From Tractor Supply Co.)
CSV125-1 Cycle Stop Valve
4" pump sleeve kit
Stainless 1-1/4" Extra Long Stainless Male Insert Adapter & Stainless Clamps
Stainless 1-1/2" to 1-1/4" Bushing

Do I have anything wrong?

Thanks,

John
 

Valveman

Cary Austin
Staff member
Messages
14,599
Reaction score
1,296
Points
113
Location
Lubbock, Texas
Website
cyclestopvalves.com
Looks like everything you need except a pressure tank, pressure switch, and a few fittings for those. If you get the PK125 kit instead of just the CSV125, the kit will have all the fittings, tank, and switch that you need.
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks