90 degree vent elbow on standpipe trap arm

Users who are viewing this thread

evolution2147

New Member
Messages
13
Reaction score
1
Points
3
Location
AZ
Hello everyone, Opened up my wall and I am finally getting around to adding my utility sink to the laundry area. Since I have to remove the san tee fitting in the picture I figured I mind as well flip the stand pipe to the other side since the washer is on the left anyways. My question comes from the original plumbing in the picture. Is it ok to have a sharp vent elbow on the trap arm? I am planning on replicating this setup on the left side but want to make sure this is ok first. This is the original plumbing that was installed in 1981. If this is not legal I will have to draw up a new config since its a tight space.

Thanks
 

Attachments

  • IMG_0253.jpeg
    IMG_0253.jpeg
    102.3 KB · Views: 189
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks