standpipe

Hello, everyone my name is Jason. I was hoping i could pick some brains about a clothes washer that is installed in massachusetts. I checked the forum for mass but no one goes there so I'm trying my luck here. Problem: washing machine was full of water and overflowing onto the floor. The...

In my basement, there is an existing wash sink that drains directly into the main drain line via a 1.5" pipe. The washing machine currently drains into the sink but I would like to add a standpipe for it to drain into. First off, is my current setup fine the way it is installed without a vent...

We just moved into an older home and I want to move the laundry to a different location in the basement. I have been doing quite a bit of reading and found some excellent resources on both this forum as well as others and I think I have it figured out but I was hoping I could get a second...

I am a recent new homeowner and am seeking some advice about how my dishwasher drain was plumbed. I've gotten nowhere with the builder as they're saying it's up to code and that's how they always do them. My issue is that my dishwasher runs very quiet until it begins to drain. At that point...

Thanks in advance for any help! Part 1: My laundry/utility room is unfinished and in the basement (exterior wall). We purchased a new front load washer and dryer, and it had been working well for 2 weeks or so. Right now, I have copper supply lines coming to a laundry tub and galvanized drain...

Hi! I've searched around, but haven't seen this asked so forgive me if I'm repetitive. Currently, my washing machine has to pump draining water about 5 ft and then up 3 ft before it hits the drain. The pump on my washer is tired. I could buy a new machine and wear it out or - at the...