shower

  1. dwhightowe

    Phister Avante, Need to identify this shower valve

    I need to get the knob off this shower valve so I can tighten it up. The valve itself is tight and works well, it is only the knob that is loose, but I can't see a way to remove it. There is no brand identification anywhere on it. Nor are there any screws or other fasteners visible. If I...
  2. ChrisNorthNJ

    Vent move for DIY bathroom

    First off - what a great forum this is, I'm lucky to have found it. I imagine this is an easy question for some, but as I'm a DIY homeowner I want to make sure I get some advice. We're renovating a small square bathroom with a small walk in shower. There was a wall separating the side of the...
  3. Ubaldo Alonso

    Mixet MS5AT Shower cartridge id

    Might be able to get better help here , old cartridge dead and the ones i use to replace all get stuck on the turning and low water flow . Any help ?
  4. handyguy

    Can you add a telephone shower head to an existing bath and shower setup?

    Hi, I have a standard delta setup in my bath: tub spout, upon which you pull down the lip to direct water to the shower head plumbed behind the wall. I am wondering if it is possible to replace or modify the spout, so that you have the additional telephone shower head, without losing the...
  5. Abbott

    DXV Thermostatic Valve, Who's the manufacturer

    I have to replace the diverter and I don't see any mfgr information Thanks for any help. Abbott
  6. Grim Reaper

    Thermostatic Shower Valve - Need to know the make/manufacturer

    I do not know the make/manufacturer of this Thermostatic Shower Valve that is malfunctioning. It is difficult to turn, makes a scraping sound when turned, doesn't appear to regulate temperature, hot is lukewarm even when the control is at the hottest setting. I am fairly certain I need to...
  7. DanaG

    Valley Shower Handle Removal

    I am trying to replace my shower handle and I can 't quite figure out how to remove the old handle. I have removed the lever and the escutcheon, but cannot get the rest off. I can't find any screws or anything on the handle, and I am wondering if anyone knows how to remove? Any input is appreciated!
  8. chuc

    Shower system help

    Hi all, Thanks in advance for any help here. We are doing a bathroom remodel and I feel like everyone I talk to gives me a different answer--even employees at the same plumbing supply store. I'm hoping to arrive at some sort of consensus. Our bathroom is completely torn apart, but here is a...
  9. Kyleb2112

    Push-Pull valve for brand new shower? Bad idea?

    I like the old push-pull valves because I can control water pressure with them, and I don't have to turn the knob through the "cold" region when turning off the water. Is it crazy to install one in my new shower? Do they even sell them anymore?
  10. NoahP

    Need Help With New Tub Install Creaking Around Drain

    Hey Everyone, Hoping you can help me troubleshoot an issue. I just finished installing an aquatic A2 4 piece tub with surround. Unfortunately, after I already had the drywall patched up I noticed that there is some creaking when pressure is applied around the drain. Not sure how I missed that...
  11. Baxter90

    Bathroom renovation advice:

    Hello! We’re renovating our bathroom, our plan is to gut the entire thing. However, we’re stuck on what to do about the plumbing for shower/tub. Currently they share the same wall for head/faucets. Our plan is to relocate shower to opposite wall (since we’re taking out the dividing wall it’s...
  12. Sailor

    Shower p-trap vent location and slope

    I'm remodeling my master bathroom and going with a Kerdi channel drain and larger shower extending to where we used to have a sink. I tied the new drain where the sink drain used to be. I'm wondering whether the vent should have been connected closer to the p-trap. This is the first time I do...
  13. Billy Smith

    any1 know of any shower base pans w/o pre-cut hole or ....?

    or.... should i get a plumber? Thank you Terry Love for the info a week ago about how you would have to change the plumbing underneath to match the new hole...that makes sense...... i learn something everyday....im 25 and not the best construction guy but i can figure a decent amount out...
  14. BamBoozzled

    Water leak coming from upstairs bathroom to main floor.

    Hi everyone, yesterday we noticed after 3 consecutive showers a little bit of water dripping from our main floor chandelier. We found the culprit to be coming from the upstairs bathroom. After running the toilet, and sink we realized the leak was not coming from those amenities. Not to mention...
  15. Billy Smith

    Question about Shower Base Pan Hole Install. T.Y.!

    Hello, thanks for reading this and my question i have is about when i goto put in a new shower base pan, the locating of the hole with the new kits.... will it line up or does it come as a "holeless" pan and you make a hole yourself?.....okay so i have a 5 year old shower enclosure thats getting...
  16. CMiller0104

    Wood Subfloor over Concrete Slab under Kerdi Shower Tray

    I'm hoping someone out there can help me. We've been trying to get our shower remodel underway, and we've been dealing with delay after delay. And, we're on a short timeline, since we're expecting twins in October. I'd really like to have the shower usable by then. :/ We've installed Kerdi...
  17. Jeff Elkins

    Seeking Tub Filler Solutions for Unique Freestanding Tub Situation

    We have installed a 62" freestanding tub in our small bathroom, replacing the old surround fixture. It is 3" from the back wall and 5-6" from the walls on either side (head/foot of tub). Due to COVID and the upcoming unavailability of help I rushed getting the floor tile, tub drain, and tub...
  18. -Bri

    Tub drain replacement rubber ring

    When replacing the drain on a bathtub, should there be space between the rubber gasket on top of the PVC and the bottom of the tub?
  19. Trace

    Odd size shower valve stems, smaller than 21/32

    I'm trying to replace the stems and handles in our tub after the shower handle essentially stripped and could only be turned on and off with pliers; and the pliers slowly stopped being effective as the valve stem itself started getting stripped. No clue as to what brand we have, but the...
  20. Jrichardson30

    Remove shower drain clamping ring

    DIY Guy remodeling my master bath. Planned to do everything except the shower mortar bed bc it just seemed too tricky. SO...I had some not-so-great tile guys build the mud bed for my shower. They installed drain, pan liner and did the mud bed. They messed it up, isn’t level and not sloped...
Back
Top