mixing valve

  1. Terry

    The Mixing Valve Connector

    https://themixingvalveconnector.myshopify.com/ I saw this email today about a new product for adding a mixing valve to a sink.
  2. Dmwesq

    Hot Water Heater Mixing Valve or Not

    I'm having my 38 gallon Bradford White HWH replaced Monday (under warranty). I am contemplating having the plumber install a thermostatic mixing valve at that time. I have a friend who says I shouldn't add the valve because it adds a level of annual maintenance to the HWH. Just wondering what...
  3. HighlandsBoy

    [Hydronic Open Loop] No Hot Water Unless Circ Pump On

    Hi all! Short-time reader, first-time poster. I just moved into (renting) a Seattle-area townhouse and have realized my heating system is, unfortunately, a hydronic open loop (in-wall forced air radiant) system using a standard hot water tank that is shared with the domestic water system. The...
  4. Terry

    HansGrohe PuraVida tub shower valve, 15771XX1

    HansGrohe PuraVida tub shower valve, 15771xx1 with the PuraVida rain shower, 27390xx1 What I'm installing is a thermostatic valve that switches between the rain shower and the tub spout there. Two positions. PuraVida 27437xx1 Control Valve PuraVida 15412401 Tub Spout PuraVida 27390 Rain...
  5. Pwdhomeowner

    Exterior mixing valve for washing machine

    Our tap water here seems to be about 50° or so. I want to mix in a small amount of hot water into the Cold for the washing machine cold water inlet, so that the inlet water is tepid rather than super cold. It is intended for a bidet I believe. I have a mixing valve with a built-in one way flow...
  6. Christian P

    Oil fired Boiler doesn't heat water properly and creates banging noise

    Bought a home a few months ago and still struggling to set up my boiler correctly. I have a SlantFin Liberty Oil fired cast iron boiler heating up two heating zones through baseboards and the water in the house. After the first few weeks, I noticed two things: 1) Baseboards around the house...
  7. Westallstar00

    Hot water out on tub replacement

    I am replacing my yellow tub with a white acrylic tub. I turned off the water to our bathrooms 2 days ago to start demo and have turned it back on whenever I'm not working on it. Today I determined I needed to raise the faucet to accommodate the taller tub. Figuring this would be a good...
  8. PeterLewis

    Shower mixing valve cartridge - identification - Sayco? Aquabrass?

    Hi folks, I have a single shower mixing valve that doesn't mix any longer. I've removed the cartridge but can't identify it. Been to 2 plumbing supply stores and no luck there either. Going through previous posts, it looks like a Sayco or a Aquabrass cartridge to me but I'm not sure and I...
  9. Cold Feet

    Circulator-Mixing Valve Orientation

    Thanks in advance for any help with this issue everyone. I recently installed a new WM Aqua-Balance 120C combi boiler in my 2-story 1911 craftsman. I have CI rads on the first and second floors that were running on one zone previously. As part of this project I zoned the floors separately...
  10. Adam Farrow

    Radiant floor with tankless Combi boiler on wood stove

    Before I start calling plumbers I want to know if this is possible and what I need to see if I'm choosing the correct installer. I want a radiant floor heat powered by a wood stove and tankless combiboiler when wood fire dies I want the tankless to pick up the demand. The tankless will be used...
  11. diwhat

    Mystery of the Day: Bad Washer or Missing a Part on This Fixture ?

    This the faucet and stem from an 8 inch spread three hole bathroom sink. Problem: When either the hot or cold water handles are turned on, water drips out the bottom of the spout shank (underneath the sink) and very little or no water at all actually comes out the spout itself. As you can see...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks