Search results

Only factory service might be able to change the whole burner operation. Ran some numbers 60° cold, 120° hot 105° mixed, 1.6 gpm total, .4 gpm 25% cold , 1.2gpm hot ,75% hot. By throttling hot water down to 1.2 gpm might help or playing with the wh setpoint maybe raise or lower it by 2° at a...

Your only treating waterside. Burner can be 3500°+. The hx water is moving fast. I've seen hx twisted like a pretzel in a copper fin hx from low flow , scaled or flow switch isn't fast enough. Passivation burner side isn't touched. Plate and frame both sides can be treated or shell and tube. Hx...

Tank 1 stage reg should be set at 10 lbs. Second stage at house 11". Did you see the on the conversion manual last page has burner side lp pressure.

Have a regulator before the burner? Btu rating of burner?

Need a gauge that will attach to either to a outdoor hose bib or at the clothes washer valve to measure the water pressure. They open at 150 psi or 210°. They might start dripping at 140 lbs...

Motel unit called a PTAC through the wall. Comes in straight cooling, heat pump or with electric heat. Window ac mounted in the wall.

If you have the room could just buy the flanges 2- 1.250" screwed ball valves and 2 nipples that's if you need the valves

Run a separate lines outside that pan under the heater if the tpv would let go water would be splashing out of it

Vent probably blocked. Sewer person needs to cable vent and lines.

2.31 ' = 1 lb of pressure doesn't matter what size pipe.

Slimline radiators not fin tube what temp water? Their all probably very close. What water temp do u what to run. Are u thinking 140° +f or less.Less is a heat pump.

No i can't but I've never tried another brand because i can't afford a problem. No different than replacing a pump or a cartridge. Labor cost to much. What advantage would another company have

Stop want is the lp pressure incoming? What is is it out? Is this a lp unit?

What are using to maintain level in the storage tanks.280 gallons of storage how long does it take to refill?

Asking for a combi water heater? I've only seen it done on process equipment. Never seen it done on a plate and frame hx used for condenser, chilled or heated water.

A catch pan for a tp relief devise is like there is no way it's big enough. A devise could fail wide open or at least fail part open.

Have any idea who the builder was? Call them for the plumber company. Your in the process of buying a house and the realtor doesn't know some company sad. The owner doesn't know who to call. I'd be very skeptical. Good home inspector should know. On Facebook post a question on septic systems...

Just Google sewage lift pump system explained. There are two types of pumps sewage and grinder. Grinder pump is probably what u have it handles toilet waste.

There some good videos on tdh on you tube and how to pick the right sewage pump.

Ask the plumbing company to have the local rep of navian to meet with your plumber at the house. They are plumbers that haven't been trained on the correct installation of two units.