Search results

Can’t get the pic to go through.

I temporarily hooked it up this way until I can get some quotes or figure out a permanent solution that I can do myself.

Found where it goes up through the slab.Can I just drill through that section of siding and run the line through there? The small section that would run up the side I would insulate.

Anyone know about where the water line would come out through the slab?

There is not a shutoff valve.

Thanks for everyone’s suggestions.Found it.Looks like it’s leaking where the pipe enters the foundation.At least that’s where I saw some pinhole leaks,don’t know if there are more further in.Talked to a plumber and he said the would abandon that line and run a new one to the water heater.Can...

Hello.I Had the City stop By while I was on a business trip and told my wife that the house has a leak at 1.5 gallons a minute.What would be the process of me figuring out where the leak is? Thanks in advance.

Looks like I’m going to change to solvent weld,because when I did the leak test water leaked onto the roof below.I remodeled my master in December with a new shower and freestanding tub and no leaks with solvent weld.Should have went that route from the get go.

I have a whole new assembly from a kit that I bought.I can just take the cartridge out of that one,but would that still be my best bet? Home is 10 years old.

Hello.I am in the process of remodeling my kids bathroom and after I replaced their tub and started filling it I noticed that their was a slight drip from the valve cartridge at the center of it where you turn the water on and off.Can I just replace the cartridge and be good or does the whole...

Do the slip fittings have a tendency to leak more?

Thank you.Is there a way to test for leaks if I don’t have access to the pipes once the tub is installed?

Hello.I am in the process of redoing my kids bathroom and I have a question regarding the plumbing for it.I purchased a kit from HD that has the oil rubbed bronze hardware that we are looking for,but the kit has slip fittings.Are these still good or do I need the solvent type?

Old thread but was hoping to find out how the Bootz tub worked out for you?

Anyone?

Hello.I recently installed a Kohler toilet with aqua piston and once installed I noticed that the flush lever screw was loose so it would not engage to lift the chain in order to flush.I tightened it with some pliers and it worked for a little bit,but it’s loose again.Tried every bit that I have...

Thanks.I did install the tile under the flange after your response and the toilet is installed now.So far so good.

Where the videos saying that a pre slope was not required by Starrtile?

Thanks Terry.I actually found the fittings at HD and they were 1/2 to 1/2.Heres a pic

Hello.Im getting close to installing a standup tub filler and wondering what fittings I need on the PEX pipe end to connect to it.If someone can help me out with this I would greatly appreciate it. Attached are pics of the hoses that connect to the filler and also the 1/2 inch PEX.