Search results

I found this task nearly impossible when I looked. Even high end brands were plastic. We did find the Pfister Briarsfield which is all metal and have been happy with the faucet. We have had it about 1.5 years.

Thanks!

Hello, I normally use Pro’s Pick blue salt and it seems to work well. I have to go to a specialty store to buy it which is not the most convenient. Ate there other types of salt that I should consider which might be more easily available? chris

Yes it is indoors in the basement.

The company came back to me after my initial question and offered to replace the PVC with PEX. Should I agree to have them do it? Thanks.

Thank you. I won’t ask them about it further.

Hi All, They install the well tap for my irrigation system. I noticed they connected PVC directly to the well pipe. I didn’t think you were supposed to do this. Please let me know. Picture attached.

hi, I have two quotes for an irrigation system for 60k sq ft lawn. The prices are quite similar and both use hunter products. The main difference is that one contractor says the rotors should be 25’ apart and the other designed theirs for 35’. Is there an ideal radius? This system is going...

Thanks. I added two more bags which put it above the water level. Probably could throw one more in.

Hi, Every time I check my salt there seems to be a lot of water in the tank. Should I be worried about this? Please advise. Salt is around 1/3 level In the pictures. Thanks.

Thanks all. I updated the settings per your recommendations.

Looks like a 25

I am sorry Reach4. Typo on my BF. It is currently set to 16.

Thanks. I will check the BLFC fitting. I found it in the parts diagram and will look into it tonight.

Is this helpful? Here are the rest of the settings. VT = 5810 RF =dF2b CT = Fd C = 60.0 x1000 H = 24 (I found some advice to increase by 5 for every 1ppm iron??) SF = 10 RS = cr DO = 7 (I found some advice to lower to 7 if you have iron??) RT = 2:00 B1 = 6 Bd = 60 B2 = 3 BF = 6 FM =t1.2 RE =...

Thanks. I will plan to look for the label this evening.

Hi, I have been living with the new softener for a couple of weeks now and we are quite satisfied with the water. I don't know if my settings are optimal. I have only adjusted a few using the simple menu. Please help me make sure everything is correct. Also I have some citric acid to add to...

Trying the picture again.

I think there is a check valve too.

I am getting multiple bangs when we turn the hot water on. It bangs probably for a few seconds and then dies down. The banging sounds like it is coming right at the ball valve.