Search results

  1. quartermilecamel

    Delta 38 neo shower base with unlevel floor using levelquick rs stil not quite level

    Ive poured levelquick rs over the unlevel floor in a 1909 house with tongue and groove floor with half inch plywood over that, and now its much better, but still rocks a bit corner to front. It had a 9/16 gap at the front before the level quick. Do I just top it off with regular mortar or pour...
  2. quartermilecamel

    Installing delta 38 new shower and drain issues Ive had before. Proper way to install oatey shower no caulk drain

    Ive seen the oatey shower drain no caulk and it shows the install with fibre and rubber gasket on bottom and using plumbers putty on top, yet I have had problems with it leaking in the past with the old shower drain pan. Plumbers putty is oil based and IM sure its not supposed to be used with...
  3. quartermilecamel

    Installing new delta neo stainless steel shower. How perfectly plumb do the walls have to be. MOst of the bubble is centered in the level glass line

    How much out of plumb is still acceptable for a new neo delta shower install? If out of plumb how does one even adjust for that?
  4. quartermilecamel

    Hot water kitchen faucet valve squeaky from lack of grease. Cold water valve is fine only hot water valve constantly needs greased

    I have to constantly grease my hotwater kitchen sink valve or it has that binding o ring squeaky sound where as the cold water doesnt need regreased. Im using ace hardware plumbers grease. Is there a special hot water grease?
  5. quartermilecamel

    Water right sanitizer series softener needs resin replaced is it worth it and if so how

    I have the sanitizer series with chlorine generator and zeolite resin put in in 2008. waters not real soft anymore. Thinking about replacing the resin myself. Suggested cost of people to do it that are now Culligan and were water pro when I bought it said 500 bucks just to replace the resin...
  6. quartermilecamel

    hot water sink on off knob is squeaky like the rubber o rings are dry yet cold no squeak

    I keep on greasing the hot water valve but it doesnt last long yet the cold water knob doesnt do this. Is there a proper grease for this? I have well water and a water rite sanitizer series softener thats 12 years old. what can I do to get this valve to stop the rubbery squeak sound when the...
  7. quartermilecamel

    New bladder tank or CSV valve with small tank and Grundfos sq200

    Ok here's the total situation: Well x trol tank bladder busted after 2 years.....found out zero warranty because I installed it myself. I originally set it up for 40/60 pressure and tank bladder set at 33 psi. Worked great...until now. Really don't want to spend 250 for labor just to have...
  8. quartermilecamel

    Winchester furnace(York) blower fan wiring for fan only

    Hello I have a york furnace 1996 model. control board blew about 2006, replaced with newer version. Old board had heat park and park terminals I dont think it even had cool terminals. This is a heat only furnace as in no cooling so blower motor black wire is connected to heat terminal. This...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks