Search results

thx for the replies.. i tried the torch, but i'd probably go through about 20 cans of gas before its done so i got a heat gun... it works good but the progress will be quite slow. so maybe ill be done by next week haha. thanks for the help.

I am taking down an addition someone put up on this house a while ago. As you can see they were not pros.. I'm not sure what this is, but I need some suggestions on the best way to remove it. They used tons of this glue, and nails, to haing this stuff up to cover the brick. I want to try to...

Does anyone know how to set the float valve to take some water from the bottom drain? I have a little sand collection at the bottom of the pool that i would like to just push by the drain and hae it sucked into the filter. If i close the valve completly, it just pulls in almost nothing so i'm...

thanks for the tips first of all, I would have never thought about debris clogging things up, and now i'm 99.9% sure thats what it is. soder and copper. I dont know how but there was a dime sized hole about 4" below the ground level.

I had to patch a piece of pipe today (outside) which I think was the main line into the house, it was 3/4". Everything works fine after I replaced the pipe except that the kitchen sink cold water has very low pressure, and so do the toilets... they take about 10 minutes to fill the tank. The...

wow, thanks for all the replies. I had it hooked up and then had some leaks from not tightening it enough. So I installed some of the unions and it works great. Appreciate all of the replies.

I am hooking up pool equipment and am not sure what to use. What i have now would require me to cut the pipe everytime i want to remove the fitting. IE, if want to change the sand in the filter, i would have to cut the piping. Do they make fittings that would allow me to just screw off the end...