Search results

We tought than the pressure was inadequate with the old piping and fixtures... Now than we replaced almost everything starting at the water softener, the pressure and volume are good. This is why I consider replacing a section of the trunk to a smaller diameter pipe. I would replace a section...

I'm concerned with both i guess... If I understand correctly, I would home run 3/8" to faucets wich would reduce wait time for faucets, and keep the 3/4" Trunk to the shower and to bath? Or do you mean home run hot in 3/8 to all fixtures requiring hot water of the bath group (2 lavs, one shower...

Hello, I just completed a full house remodel and all went (relatively) fine, but as always, little annoyances reveals themselves after all is done, when you live in the house. One problem I have is the wait time for hot water in one bathroom. I ran 3/4" pex trunk lines the full lenght of the...

Thanks Bill for the answer. I will add 2 cleanouts, one for each sink, between the santee and the 45 bend. Thoses will be accessibles inside the sink cabinet. Living here up north, you know how cold ours winters can be, so you might be well placed to answer one of my questions : can you put...

2" minimum for drains then : Is this ok that way? If not, how could I improve the layout? Thanks !

Hello, Thanks hj for your answer. I've been reading your posts for quite some time, and I know than if I follow your advices, I will get a good design. The cleanouts will be accessibles between joists as the room below the bathroom will never get a finished ceiling, is it possible to "snake"...

Hello, First, let me say this is a great site with lot of knowledgeable people, it definitely helped me so far ! I'm planning to relocate a bathroom in my house, enlarging it and adding a bathtub and a shower. This is a one storey house, and the basement under the bathroom will never get...