Search results

For my project I've been using Uponor PEX pipe with ProPEX fittings and the Milwaukee expansion tool. Is it safe/acceptable for me to use non-ProPEX fittings with the Uponor PEX pipe? Many Thanks

Im interested to know how someone more knowledgeable would handle this. My new vanity has a divider inside that will sit very close to my cold water inlet. Things will fit just fine but thinking toward the future there would be no room to work if/when something needs fixing there. If I move...

I'm replacing some galvanized 2" drain/vent. Comparing these two types of couplers, is there a time I shouldn't use one over the other? When piecing last bits together it is not possible to use the one with the rib on the inside mid section. Seems like it wouldn't be a problem on the vents. Is...

While remodeling my 1st floor bathroom I've got all walls open and I was wondering if I should replace my clothes washer drain line from 1.5" to 2". I thought I'd get some advice if this was worth the effort. Mind you, though sometimes these jobs may seem simple to some they never are, at...

The 3" drain line from the 2nd floor runs down my shower wet wall. This is cramping me with my desire to center my new shower valve which uses a Grohe GrohFlex rough-in. This new one is much bigger than the original valve. Do I have any plausible options to, perhaps, add a couple soft bends...

(Referred here from JohnBridge) I removed fiberglass tub/shower and will build tile shower in its place. Drain will be moved to center of the shower. 1) What is best way to tie in from new drain location (which will be the center of the original tub area)? Direct to original location and...

This is on the hot water line. What is this from? Should I do something to clean it up? Can I/should I do something to stop it from occurring? Many Thanks

House in So. California, built around 1965. Doing a master bath remodel. Did demo of the stall shower and found this in the plumbing wall. I'm sure this is vent pipes, but I don't know why the cleanout opening (if that's what it is called?) that was in the wall. What is this for? I will be...

Hello All, I have a clog at the master bath sink. I have tried to snake it but can't get it cleared. Called a pro and he could not get it cleared. The Pro suggested cutting into the pipe near the clog. By snake depth of about 5' I think that probably possibly my very hard clog is in the...