Search results

Thanks for the reply. I have water tested and no problems. I used the Mark E. Industries Pre-Pitch and Quick-Pitch sticks. Worked pretty well. The "Goof Proof Shower Kit" includes a weep hole protector plastic flange. I plan on using an epoxy grout, but not sure which one...haven't gotten...

So which sand to mix with Portland Cement? Quikrete All-Purpose sand or Quikrete Play Sand? For the pre-slope in a shower floor, I used the All Purpose sand in a 4:1 ratio, but it seemed the sand was a little coarse. For the tile bed, I want to use play sand, because I think it would be...

So is it best to run 3/4" pipe all the way until just before the fixture? Where is the optimal place for the reducer, since the fixtures (body sprays in this case) are 1/2"? Should the pressure balancing loop be 3/4" or 1/2"?

So while I was putting the floor back over the top of the shower drain, I must have broken the bond between the vertical pipe and the p trap. Is there an easy fix or do I have to tear it all out and rebuild?

Is it ok to put a gate valve shutoff under the floor? I am remodeling my 2nd floor bathroom and put in gate valves so that I can plumb the shower without turning off the whole house water...since I don't have a long time each day to do the plumbing, it is easier to tackle this way. If I...