Search results

I am installing an undersink pump to service a utility sink and bar sink in my basement. I have all the vents and discharge pipes installed. I am trying to figure out the best way to mount or stabilize the discharge pipe. It runs upwards at an ~8 degree angle (as shown in the picture below)...

Currently roughing in two basement sinks (one for bar, one for workshop)...they will be on opposite sides of a wall. Trying to figure out how to vent this arrangement properly. I plan to have each sink on their own p-traps and separate drain lines into each side of the pump. I will vent the...

I am getting ready to set up my water softener. We have 2-1/2 baths, 2 adults and 2 kids on well water. Our water hardness is 31 gpg with trace amounts of iron (post greensand filter). I think our flow rate is around 3 GPM (filled up 3 gallon pale in bathtub). We have high chloride in our...