Search results

I'm going to be installing a softener and filters for my well water. I have a spin down filter for course sediment and a multi-stage sediment filter for smaller sediment. What I have is more or less what is depicted in the attached picture (came with the spin down filter). I don't have a UV...

Thanks...yes, I've thought of that. My space is tight but I'll make it work.

Thank you. Could you recommend a filter? I can certainly look for a different source but I'd like to get one that is reputable.

I have a well that is 400-450' deep with a 3/4 HP pump (from the early 1970's and still going strong). I had the pressure tank replaced about two years ago and now have a 32 gallon tank. The 1" pipe from the well goes into the pressure tank, is reduced to 3/4", then goes to a 10x2.5" whole house...

Thanks, sorry, I mean't 2" and 1.5". My concern was just making sure it was ok to use a vent pipe that is smaller than the trap/drain. The reason I was going with Option 2 from the link and not Option 1 (I think this is what you are suggesting), is that my trap arm is going to extend into the...

I am needing to re-locate my laundry room. I got a quote for the work that was way more than I can afford currently so I'm going to try and tackle this myself. Some of the decisions I've made (e.g. using a mechanical vent) are b/c I have to get this done quickly and as inexpensively as possible...

Oh...one other question...in order to make it work, I installed a branch tailpiece on the other side (i.e. the dishwasher used to go into the disposer, now it's on the other bowl). There isn't any problem with that, is there?

Thanks for the replies. I ended up going without the disposal. Even at that, one of the traps was difficult...probably a little less than a half inch off. I did get it all together, though and it drains fine and doesn't leak. I would open the wall but we're listing the house for sale...let the...

After searching around a little more, I think I see what my real problem is. The disposal outlet is a/b 1.5 inches below the drain so it will retain water. I've seen it mentioned that different disposers may have different outlet heights. Does anyone know an inexpensive disposer that is likely...

I replaced my countertop and sink and have to align the traps/drains with the new sink, which is deeper and a few inches off of where the old one lined up. There are two traps, one on each bowl and one of them has a disposer. I managed to get the trap on the main bowl without too much trouble...

I have a Moen faucet that's leaking and have no idea how to fix it. I've attached a picture of it...hopefully it is posted. I also circled the area at the base of the faucet where it is leaking. I found the following parts list on line for the particular model (at least it looks like...