Search results

https://www.slantfin.com/revital-line-series/

Anyone know of company that makes these for standard copper unions?

During a bath remodel I had a pro come in to help with plumbing. As it turns out it's a disaster. I can't have him back again. There are 2 bathrooms one above the other. A sewage pump up ejector was installed in the lower bath years ago, it was vented to the main horizontal vent in the upstairs...

Top of sink is flush against the tiled wall and level in both directions but there is a gap on the underside where the hanger bolts go and all across the width of the sink. It seems some sort of spacer will be needed prior to tightening down on the hanger bolts. I was wondering if any of you...

How far up should the soil pipe go into the toilet flange? This would seem to have another inch to go. Thanks. https://www.screencast.com/t/PmadOBuisSQ7 I posted this in the toilet discussion forum earlier but perhaps this area is more suited to the question.

How far up should the soil pipe go into the flange? This would seem to have another inch to go. Thanks. https://www.screencast.com/t/PmadOBuisSQ7

Deleted

This is a 23 year old non-condensing boiler. Recently it has begun to create condensate all the time, no matter what the return water temperature is. This boiler runs 180F degree water to baseboard radiators. Flames on at 150F so what's happening with the condensate issue?

Failure happened again on 08/11/14. It seems at several month intervals (aprox 6mo) the boiler pressure relief valve will open releasing water. The pressure gauge shows a abnormal pressure reading of 30lbs. The street boiler fill valve is closed so the only other place I know of that could...

Anyone have some experience with this tank? Do you have any information on the coil in it? The flyer page says "specially formulated flow coat technology enamel heat exchanger" and I'm not at all sure what that is?