Search results

Thanks, Jimbo.

I am planning to install ball valves in 1/2" cpvc supply lines in my basement. Locally, available ball valves are brass and available male adapters/connectors with cpvc solvent weld capacity are all stainless steel. is it ok to connect the stainless with the brass? Thanks for any advice.

Thank you Thanks to all of you for the help.

Thanks, liquidplumber. There is no toilet upstream but there is a bathroom sink and a kitchen sink. Does the rule you mention apply to these?

Thanks TS and HJ: Thanks for your responses. TS: To answer your question, this is part of a renovation project. I'm replacing pipes upstream from what I've drawn in order to deal with some drain slope issues and thought I might put everything else in order. I was just unsure about proper...

Hello - I have what appears to be an unvented bath trap. Pic shows the current set up and what I'd like to do about it. Depicted plumbing is in my cellar. The bath drains into a 4" horizontal pipe downstream from a vertical 4" stack that goes throught the roof (single storey bldg) via a 2X6...