Search results

I hate to ask such a basic question, but.... I'm about to install my new Delta R1000 rough valve. What size wood do you guys use for the stringer? By my arithmetic, it looks like it should be about 1.5 inches from the back of the studs. Shower framing is 2x4s, 1/2" permabase, Kerdi, 1/4" thick...

Plumbing for my new bathroom is almost done. Insulating should go quickly. So, I'm on to thinking about the tile. The shower is 3x4', no tub; tile will probably go to the ceiling. I'll be making a mud bed. What waterproofing system do you guys recommend for a novice? I'd planned on Kerdi, after...

I fought for a day, trying to get a decent joint with Oatey #95, tinning flux. Then, I tried Oatey #5, paste flux. worked like a champ. I even went back, cut out and re-did the three joints I did yesterday. The #95 had come in a "kit" with solder, brush, emery cloth. What's the #95 good for...

Hi all. I'm signing in from Atlanta, Ga. I've been reading and lurking a while, but this is my first post. I'm getting ready to start the plumbing on my master bathroom addition. Since it's an addition, all four walls sit over rim joists and block walls. There's no access to any bottom...