Search results

How can I tell if my water pressure is sufficient to do this? I can remove the shower head and measure the GPM and/or PSI. Is that information enough to make a decision. How much would I need? Rich

I have torn out the vanity and am going to replace it with a pedestal sink. The pipes are galvanized and both the hot and cold have an air chamber for water hammer. I am switching to copper, is the air chamber neccessary? Rich

Installed just 5 months ago. It's PricePfister, three controls, one for hot and one for cold the middle is the diverter. Worked great for 5 months but now will not divert to shower. When the handle is turned the tub shuts off but no water flows to showerhead. Have taken the diverter apart as...

Do I use any adhesive and what kind? The countertop is granite tile and the sink is marble. Rich

Toilet is Standard Collection by American Standard. It will not completly flush, the water level stays the same in the bowl. If water is poured into the bowl it will empty. I have removed the toilet, wax seal looks great, can't see anything from the bottom. Tried a couple of adjustments...

Solids okay but if just a little bit of toilet papet is used it won't go down. I noticed that the bowl does not empty, but the tank fills to the correct height. When installed the whole toilet had to be slid forward a bit for the tank lid to fit on, due to the wall being built out a bit with...