Search results

  1. walt_pittsburgh

    Fluidmaster 400A shuts off but then slowely fills to the top of the fill tube

    This was installed a few years ago and has been fine until recently. I have the float to fill to around 1" below the top of the fill tube when it will shut off, but after an hour or so, (it must run very slowly) it will increase the water level right to the top of the tube or just below the top...
  2. walt_pittsburgh

    Varying water pressure

    I find that every few months I have to adjust the main pressure valve in our house to bring up the water pressure. I try to keep it between 50 and 60psi. This is fine for my wife and me. It is just 2 of us in the house. Every few months I will notice a loss of pressure. A test will reveal it...
  3. walt_pittsburgh

    GFCI in unfinished basement on a 220v motor load

    I installed a 2P standard breaker to control both a Delta 220v cabinet saw and a Jet 220v planer. I have a wall outlet in an unfinished area of the basement (my workroom) with a 220v receptacle. It then has a rather short (approx 8-10ft) heavy duty extension with the correct 220v plug and...
Top
✖
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks