Search results

Hi, I am trying to install my first toilet. It is a toto drake 1.6 gal round. My closet flange is a sioux metal/abs type and sits on top of a tile floor (it is tight to the floor and secured with 6 screws). When I tested it for level it had a very slight front to back rock which was too small...

Hi, I purchased a price pfister selia faucet for my kitchen and it has integrated 35" PEX supply lines that seem pretty rigid. They are much considerably longer than I need and I seriously doubt I can bend them as would be needed without kinking them, not too mention the stress they would put...

I have never installed a acrylic tub (or any other type for that matter) and had a concern about the underside of the tub I purchased. I understand that the drain shoe has a rubber gasket that goes between the shoe flange and the underside of the tub but the tub but wondered if the underside of...

To make a long story short, the 5x32 whirlpool tub I had ordered could not take the in-line heater that the store said it would so I am going to order another model (looking to go with air injectors instead of whirlpool jets) and wondered what the opinions are between the two brands. One...

Hi again, I am in the process of moving my closet flange for my new toto drake and am reconnecting my waste line and the vent. I need a fernco fitting for the vent line (3" abs to 3" abs) and the connection will be concealed under the subfloor. There is about a quarter inch gap between the...

Hi, I am moving a closet flange and had a question regarding which abs fitting to use when reconnecting to the vent stack. I will be cutting the vent line a bit below the subfloor and drain line to the right of the 90 degree fitting. I will then install a new coupler and run new abs pipe...

Hi all, Very glad I found this forum as I am remodeling a bathroom at have a question regarding what my options are for the two whirlpool tubs I am considering. I pulled out a standard 5'x30" tub and want to replace it with an American Standard 32" wide whirlpool tub. The tub I prefer is...