Search results

Hello, I have a Leviton 9462-P 60 Amp plug and would like to connect it to 4/3 extension wire. Do you know where I can find 4/3 extension wire? I can only find 6/3 extension wire. Also, I am using this on a device that only has 3 connections. One for L (or X), another for N (or Y), and...

Hi, I have an RO system hook up and was hoping if you could inform me when or how often I should change out the filters. Should it be changed out whenever the water starts coming out slowly, this should indicate that the filters are getting clogged and need changing or should it be changed at...

Hi there, Got some scratches on my new stainless steel kohler sink. It was an expensive one too. Would a green scotchbrite pad with Bar Keepers Friend cleanser scrubing with the grain of the steel do the trick or should I use something else. Not sure if the green will make it worse or...

Hi all, Got some questions if you don't mind answering. 1) Is access needed for drainage fittings on a bathtub? You usually use a drain waste and overflow assembly with trap here but I was wondering if I could keep it conceiled if I solvent glued the fittings instead of used a slip joint...

My drainage system is on a septic system. How do I find out where the drain pipe runs under my slab of concrete. At one end of the house the drain pipe goes down into the concrete. The septic tank is located on the other side of the house (backyard) where it is annually drained though a pvc...

How wide do they make bath doors in. I would like one for my whirlpool that I will be getting. These things can get quite long so I don't know if they even make any that will fit. Probably do though. The whirlpool will be up against three walls and one side (long) open. Perhaps a sliding...

Hi all, We are going to be moving our bathroom over because the location of it right know is awkward. I live in a Very cold area (freezing) and the toilet, tub, and shower are going to be located on a wall that is an exterior wall. piping such as supply and drainage cannot be run in a wall...

Is there any place online that lists the nationally most common plumbing codes. Thanks ;)

How would a typical installer tackle this installation. I have a well that I would like too install a pressure tank on. I live in a place that has a required burial depth of below 6 feet. The room inside where they would typically install the pressure tank where there is a drain located and...

Hello, first thanks for the generous help. I have a sump pump in a well that is connected to three hydrants. For some reason the water pressure is reduces. I was wondering what the possible problems for this could be so I could fix it (i.e. the o rings are worn out and the water is...

Hello, I have a problem. I mixed up my electrical wire solder (stuff with lead in it) with my plumbing solder when I repaired my 5/8" copper pipe for a hydrant that waters my horses. I only used it to on 2 joints but should I still be worried. Thanks :D

Hello, First off thank you much for the site and help. I have a well pump that we use to run our outside hydrants. We don't use this well pump for our house water but instead our house is on the city water. The outside hydrants are used primarily to water the lawn and water the livestock...